Cylinder 2 misfire, intake vanos fault on cold start up, oil pressure control code. Pulled spark plug on cylinder 2 and is worn, looks to be original plugs. Swapped ignition coil from 2 to 1 and misfire followed. Recommend replacing spark plugs and coils. Oil pressure sensor has proper power and ground, found large amount of resistance in sensor itself (13.5 mega ohms). Recommend replacing oil pressure sensor. Vanos solenoids passed testing. Excessive engine sludge can clog solenoids and effect readings, recommend oil system cleaning and monitoring to see if code comes back.
VALVE COVER GASKET – Remove & Replace – 30i
SPARK PLUGS – Remove & Replace – 30i
OIL PRESSURE SENSOR – Remove & Replace
Don B. gave our service a 5 star review on 7/6/2021
Remove and replace automatic transmission filter and gasket. Added fresh transmission fluid. Inspect for leaks. Road test vehicle.
Remove Cover, Old Gasket Material & Drain Old Fluid. Inspect Used Fluid/Gearbox Internals, Reassemble With New Gasket/Sealant & Fill Unit To Appropriate Level With Manufactured Recommended Fluid. Road Test Vehicle For Proper Operation. [Drain & Refill Units Where Applicable]
Replace Front & Rear Brake Sensors
Replace motor oil and install new oil filter. Lube chassis where applicable. Check fluid levels. Check tire pressure.
Road Tested Vehicle, Monitoring Steering & Suspension Behavior. Checked All Steering & Suspension Components For Wear. Checked Tire Tread Life & Set Tire Pressure. Checked/Adjusted Vehicles Front/Rear Camber, Caster, Toe & Ride Height As Needed.
SPARK PLUGS – Remove & Replace
TRANSFER CASE FLUID – Drain & Refill – [Includes: R&I Transfer Case Assembly.]
VALVE COVER GASKET – Remove & Replace
Vehicle Courtesy Check-Check brakes
Justin H. gave our service a 5 star review on 5/3/2021
2014 BMW 435i xDrive CRM Mitchell1
2021-05-04T22:00:45+00:00