Recovered, Evacuated, Dyed & Recharged Air Conditioning System While Checking Condition Of Drive Belts & A/C Lines. Rechecked A/C System Performance For Proper Operation.
CONDENSER – Remove & Replace – [DOES NOT include Air Conditioning System recover, evacuate and/or recharge.]
WATER VALVE – Remove & Replace
Mary D. gave our service a 5 star review on 7/12/2022
Flushed Brake System With New Fluid, Inspected Brake Hoses And Checked For Leaks.
Perform MotorVac’s two-line cleaning system connects to the engine using vehicle specific adapters, temporarily replacing the vehicles fuel system. During the first cleaning phase (with the engine off) the system circulates MotorVac’s powerful yet safe proprietary cleaning MV3 detergent mixed with gasoline through the components of the engines fuel system. This phase safely dissolves contaminants, gum and varnish deposits, capturing them in the unit’s ten micron filter. The air intake plenum, throttle body and intake runners are cleaned utilizing the ICS kit in conjunction with the foaming MV4 detergent. During the second cleaning phase (engine running), the injector screens, intake & exhaust valves, top of pistons, combustion chamber, oxygen sensor, and catalytic converter are cleaned. This safely dissolves and removes most of the soft carbon deposits, passing them harmlessly out with the exhaust.
Replace license plate light bulb
Replaced Front Brake Pads & Rotors
Tim A. gave our service a 5 star review on 6/29/2022
Replace motor oil and install new oil filter. Lube chassis where applicable. Check fluid levels. Check tire pressure.
AXLE SHAFT SEAL – Remove & Replace – One Side
Flush Power Steering System & Add New Fluid
Replace air Filter
Replace high mount brake light
Remove Cover, Old Gasket Material & Drain Old Fluid. Inspect Used Fluid/Gearbox Internals, Reassemble With New Gasket/Sealant & Fill Unit To Appropriate Level With Manufactured Recommended Fluid. Road Test Vehicle For Proper Operation. [Drain & Refill Units Where Applicable]
Remove Cover, Old Gasket Material & Drain Old Fluid. Inspect Used Fluid/Gearbox Internals, Reassemble With New Gasket/Sealant & Fill Unit To Appropriate Level With Manufactured Recommended Fluid. Road Test Vehicle For Proper Operation. [Drain & Refill Units Where Applicable]
Drain & Fill Unit To Appropriate Level With Manufactured Recommended Fluid. Road Test Vehicle For Proper Operation. [Drain & Refill Units Where Applicable]
Wilda S. gave our service a 5 star review on 1/14/2022
Replace motor oil and install new oil filter. Lube chassis where applicable. Check fluid levels. Check tire pressure.
Brake Inspection Front brake pad thickness: 10mm Rear brake pad thickness: 4mm Brake lines good/ no leaks. Front calipers not siezed Front Rotor warp: .003 (in spec) Brakes cleaned. Wheel cylinders leaking: no Calipers seized: no
A/C COMPRESSOR – Remove & Replace – Base,In-Line4 – [DOES NOT include Air Conditioning System recover, evacuate and/or recharge.]
Recovered, Evacuated, Dyed & Recharged Air Conditioning System While Checking Condition Of Drive Belts & A/C Lines. Rechecked A/C System Performance For Proper Operation.
EVAPORATOR ORIFICE VALVE – Remove & Replace – [DOES NOT include Air Conditioning System recover, evacuate and/or recharge.]
TIE ROD &/OR END – Remove & Replace – Inner & Outer, Both
Road Tested Vehicle, Monitoring Steering & Suspension Behavior. Checked All Steering & Suspension Components For Wear. Checked Tire Tread Life & Set Tire Pressure. Checked/Adjusted Vehicles Front/Rear Camber, Caster, Toe & Ride Height As Needed.
Replace Wiper Blades
INSTRUMENT CLUSTER – Remove & Replace
HVAC CONTROL ASSEMBLY – Remove & Replace
Lupe G. gave our service a 5 star review on 7/9/2021
Diagnose loud bang, customer couldn't figure out why. Found bullet hole in hood, cops came to look and extract, inspect if any further damage was caused. Seems to be not engaging in reverse properly. Brakes grinding